Version 2.10 History
- center-fx: most modes start with measured value
- Phase spectrum cursors in different ways
- RTTY tables can be used to manipulate all data output, even possible under remote control.
- Auto tuning for Shift-Baud measurement and Classification
- Automatic tuning for all FSK / MFSK modes with variable settings of shift and center fx, can be disabled in main menu,
setup, preferences
- FSK speed measurement increased to 2500 baud, in two steps
- CORR MOD VHF added, optional baud measurement up to 5 k baud
- Remote start added. CODE3_REMOTE_START.EXE can be called from any third
party program. Must be present in same directory as CODE300-32.EXE. Start this program together with WIN/NT, it does not use any CPU
resources.
- Optional Bit Stream output by LAN for MIL188-110
ser and 39t modes and both STANAG 4529 / 4285.
- CODAN 8580 Selcall mode included
- New online help files available
- Synop decoding enabled
- in configuration file added:
- center_fx_measured_as_default - starts each mode with measured center fx / shift
- raw_ascii_save - opens separately RAW_ASCII file for saving to disk with ALL 256 characters
- keep_recording_after_mode - keeps audio recording after closing other modules
- Font table editor now for all alphabets, also in multitasking
- Textscan in all modes, also multitasking, extended with audio rec ON /
OFF, text to disk ON/OFF
- in all modes alphabet choice for Fontedit (0-5)
included, opens correct RTTY alphabet
- keyboard commands added in mainform:
- [a] audio on
- [h] temp hold
- [p] pause record
- [r] record on / off
- [t] auto-tuning on
- [z] buffer to zero
- keyboard commands in all modules (if necessary):
- [b] manual input of baud rate (incl. leading zero)
- [c] manual input of center frequency
- [s] manual input of shift
- other keyboard commands are: (if available)
- [a] ATC, automatic tuning control on FEK mode
- [l] letter shift
- [f] figure shift
- [m] change mark space
- [h] temp hold
- [u] toggle unshift on space, shift on space
- [o] output to disk on / off
- Graphical shift settings for Twinplex
and BF6
- Pactor 2 block counter added
- Alphabet mapping also in all MIL modes
- Speed Bit Analysis block lengths to 500 max now
- M188-141: DBM blocks decoding activated, timestamp as
default.
- Terminal mode in M188-110 serial also ITA2
|